Shift in one step from simulation to MCU code

Spend your time on what matters most to your design.

With time pressures and the need for trusted results, PSIM’s F2837x Target lets you test and troubleshoot control algorithms and generate ready-to-run C code automatically. The DSP Oscilloscope gives you real-time control and waveform display.

Signup for Free Webinar Thursday September 12: Leveraging PSIM’s embedded code generation for the new TI F2837x MCU

Ready-to-run code

With SimCoder and the F2837x Target, debug and validate a control algorithm thoroughly in PSIM, and from the control schematic, generate ready-to-run C code for Texas Instruments’ F2837x series floating-point MCU.

The F2837x Target allows you to spend your time testing and troubleshooting control algorithms and hardware, instead of studying datasheets to determine details like which bits in a register need to be set so that your ADC is triggered at the beginning of a PWM duty cycle.

The generated code will work with any DSP hardware board as long as the board uses the F2837x series DSP.

PSIM supports code generation for both the single core ‘S’ and dual core ‘D’ variants. When generating code for the ‘D’ variant you need two PSIM schematics to generate code for either MCU.

Explore the Hardware Target Library

The F2837x Target library includes elements for the following DSP functions:

- A/D converter
- D/A converter
- Digital inputs and outputs
- Encoder and counter
- SCI interface
- SPI interface
- CAN bus communications
- Comparator inputs
- Interrupts including trip-zone and capture
- Clock frequency selection
- State Machines
- PWM generator, with phase shift, variable frequency, and peak current mode control

DSP Oscilloscope

Easily test, debug and modify the DSP code in a non-disruptive and non-intrusive way.

Based on the SCI interface, PSIM provides the DSP Oscilloscope function that can display the real-time waveforms of the variables inside the DSP. The DSP Oscilloscope also provides the capability to modify the value of runtime variables during real-time system operation of the physical hardware.

DSP Oscilloscope F2833x F2802 F2806

DSP Oscilloscope and C-Code Generation

Use the DSP oscilloscope to identify internal process variables of the DSP to be monitored in the PSIM schematic. When the control schematic is translated into c-code using PSIM, the necessary code will be automatically setup so that these variables can be monitored using the DSP Oscilloscope interface in real-time.

Simply select and trigger on the signals as you would in a standard oscilloscope.

Features & Benefits

Hardware code generation directly from control schematic
Hardware code generation directly from control schematic
DSP Oscilloscope for real-time control and waveform display
DSP Oscilloscope for real-time control and waveform display
Automatically configures registers and flags for all supported DSP functions
Automatically configures registers and flags for all supported DSP functions
Automatically sets up pins as digital inputs/outputs, PWM or other functions
Automatically sets up pins as digital inputs/outputs, PWM or other functions
Choose variables to be monitored with the DSP scope via the SCI interface
Choose variables to be monitored with the DSP scope via the SCI interface

"“OEM Power Systems (OEM) is a designer and manufacturer of power systems, such as AC and DC motors, drives, and generator controls, among others. Although it creates these systems primarily for the…" Read More ›

G. Pace
KRW Technologies, Inc., (Formerly LTI Power Systems [formerly O.E.M. Inc.]), Texas, U.S.A.

Accelerate innovation.

Simulate power electronics with fast and accurate software, as well as deep technical support.  Get reliable results and move your innovations forward.